● Start to record through handset or speaker phone.
● After recording, you can hear automatically the recorded message.
NOTE
● In case of first Power on, record phrase 1 to phrase 4 in sequence.
3.3 Monitoring
● Dial '18' and the customer passcode Display: 'RECORD:PLAY ?'.
● Select phrase number (5~8) to play back; Display: 'PLAYING'.
● You will hear the selected message.
NOTE
● In order to change a recorded message, record a new message following
precedure (1), so the message will be updated.
● If you perform the monitoring procedure (2) when no message is recorded,
you may hear an error tone.
● You cannot record a message while a message is being played back.
● If you stop during recording, you can neither record a new message, nor
monitor a recorded message, until the predetermined record time elapses.
● The above description specifies '18' to be dialed for recording. This number
may have been changed by data setting. Confirm the number with the installer.
NX-SERIES HYBRID KEY SYSTEM APPENDIX C DISA VOICE ANOUNCEMENT
5 - 10
5APPENDIX 1999.9.15 12:41 PM 페이지12
To Next Page
Loading...