36
3. Enter new data for all three lines.
0 = Not in group
1 = In group
4. Press # key.
(*Default: 000)
Note: A line cannot be in more than one group.
# 41 C.O. Line Incoming/Outgoing Assignment
Assigns the C.O. lines as incoming only, or incoming and outgoing.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 41.
Display shows INCOMING TRUNK followed by three digits, each of which indicates current
status of each line.*
3. Enter 0 or 1.
0 = Incoming / Outgoing
1 = Incoming only
4. Press # key.
(*Default: 000)
# 42 C.O. Line Pulse/Tone Selection
Defines which C.O. lines are to be assigned as Tone or Pulse Dialling.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 42.
Display shows TRUNK DIAL TYPE followed by three digits, each of which indicates current
status of each line.*
3. Enter 0 or 1 for all three C.O. lines.
0 = Pulse mode
1 = DTMF mode
4. Press # key.
(*Default: 111)
# 44 C.O. or PBX Line Selection
Defines which lines are directly connected to telephone company (C.O.) or PBX line.
1. Press # key.
To Next Page
Loading...