28
904 LCR Class Of Service
905 Assign PIN Code (Authorisation Code)
906 LCR Inter Digit Time
907 Dial Delay Time
908 Network Code
909 PIN Code
910 Call Cost Code
911 Dial Start Time
Programming Procedures
# 04 Enable/Disable User Programming
Sets the system into programming enable or disable mode for user-level access. (See the list of
programs above.)
1. Press key
PROGRAMMING is displayed.
2. Dial 04.
MMC DISABLED or MMC ENABLED is displayed.
3. Dial four digit password*, then dial:
0: Disable programming
1: Enable programming
4. Press key.
(*Default password is 4321.)
Note: Programming mode will automatically time out after a short period of time following the last key
sequence.
# 05 Change User Password
Changes the password for enabling user programming.
1. Press key.
2. Dial 05.
OLD PASSWORD is displayed.
3. Enter old password.*
Display changes to NEW PASSWORD.
4. Enter new four digit password. (The password cannot include * or .)
5. Press key.
(*Default password is 4321.)
Note: If a user forgets the password, a technician can get into programming using the technician’s
password.
To Next Page
Loading...