38
1. Press # key.
PROGRAMMING is displayed.
2. Dial 47.
DIAL 9 GROUP is momentarily displayed followed by three digits representing the status
of all three C.O. lines.*
3. Enter new data for all three lines.
0 = Not in group
1 = In group
4. Press # key.
(*Default: 111)
Note: A line cannot be in more than one group.
# 49 Forward C.O. Lines
Used to set C.O. lines to follow or not to follow station call forwarding.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 49.
C.O. LINE FORWARD is momentarily displayed followed by three digits representing the
current status of each C.O. line.*
3. Enter the new data for all three lines.
0 = Will not follow station call forward
1 = Will follow station call forward
4. Press # key.
(*Default: 000)
# 50 C.O. Flash Timing
Defines the length of a flash on the C.O. line.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 50.
C.O. FLASH TIME is displayed, then ‘xxxx MSEC’ is displayed.*
3. Enter four digits of flash time in compliance with C.O. requirements.
4. Press # key.
(* The flash time (xxxx) ranges from 0 ms to 0500 ms (in 100 ms steps). Default is 0100 ms.)
# 51 PBX Flash Timing
Defines the length of a flash for a line defined as a PBX line.
To Next Page
Loading...