44
# 71 System Speed Dial Restriction
Defines whether the system allows or denies long distance numbers in system speed dialling to override
toll restriction.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 71.
Display shows current status.*
3. Enter new data.
0 = Allow speed dialling to override toll restriction
1 = Deny speed dialling to override toll restriction
4. Press # key.
(* Default: 0)
# 74 Assign Headset Operation
Designates which stations are enabled for headset operation. Only keysets can be assigned this
function. System will disable hookswitch, and SPK button will act as an answer/release button.
1. Press # key.
PROGRAMMING is displayed.
2. Dial 74.
Display shows HEADSET CHECK, and then HEADSET: 1 NONE: 0 followed by current
data for all eight stations.*
3. Enter 0 or 1 for all stations.
4. Press # key.
(* Default: 00000000)
LCR Programming (Technician)
Forced LCR
If LCR is enabled on any line and the user presses the line key rather than dialling ‘9’, the system still
forces the user to use LCR.
MMC900 LCR Enable
Used to enable LCR. When LCR is enabled, a valid trunk group access code (9 or 80) must be entered
in MMC47 and 40. The NX-308’s LCR system provides a means to automatically route calls over
specific trunk groups according to the digits dialled.
The method of programming makes no assumptions about office codes, area codes or number of digits
dialled. It is therefore suitable for any country in the world with any numbering plan.
To Next Page
Loading...