25
Before connecting cables
Unfasten the screws, then remove the cover.
2
Remove the appropriate silicon bar for the
thickness of the cable to connect.
Different hole sizes and corresponding cable
thickness for each:
―
8 Ø hole x 1: Insert the 7-8 Ø cable
―
6 Ø hole x 3 : Insert the 5-6 Ø cable
―
2 Ø hole x 2 : Insert the 1-2 Ø cable
3
Insert and keep the removed
Silicone-Bar
in the
marked area to ensure it is not lost.
4
Insert the appropriate cable into the hole from
which the Silicone-Bar was removed.
5
The cable should be connected as shown.
6
Close the cover, then fasten the screws.
―
After all the cables are connected, make sure to
close the cover and fasten the screws to ensure
it is water tight.
Silicone-Bar
To Next Page
Loading...
