Samsung PM43F - Page 27

27
Chapter 2. Device setup
Setting PIP on/off (Set the PIP ON/OFF)
Header Command ID Data
length
Data Checksum
0xAA 0x3C 1 “PIP”
“PIP”: A code used to turn the PIP mode of a product on or off
• 
• 
Ack
Header Command ID Data
length
Ack /
Nak
r-CMD Val1 Checksum
0xAA 0xFF 3 ‘A’ 0x3C “PIP”
“PIP”: A code used to turn the PIP mode of a product on or off
Nak
Header Command ID Data
length
Ack /
Nak
r-CMD Val1 Checksum
0xAA 0xFF 3 ‘N’ 0x3C “ERR”
“ERR” : A code showing what error has occurred.
Auto adjustment control (PC and BNC only)
Function
• Automatically adjust the PC system screen using a PC.
Viewing auto adjustment state (Get Auto Adjustment Status)
• None
Setting auto adjustment (Set Auto Adjustment)
Header Command ID Data
length
Data Checksum
0xAA 0x3D 1 “Auto
Adjustment”
“Auto Adjustment”: 0x00 (at all times)
Ack
Header Command ID Data
length
Ack /
Nak
r-CMD Val1 Checksum
0xAA 0xFF 3 ‘A’ 0x3D “Auto
Adjustment”
Nak
Header Command ID Data
length
Ack /
Nak
r-CMD Val1 Checksum
0xAA 0xFF 3 ‘N’ 0x3D “ERR”
“ERR” : A code showing what error has occurred.
Video Wall Mode Control
Function
• Video Wall mode can be activated on a product using a PC.
• This control is only available on a product whose Video Wall is enabled.
Viewing video wall mode (Get Video Wall Mode)
Header Command ID Data length Checksum
0xAA 0x5C 0