Pulling, pushing, or climbing on the TV may cause the TV to fall. In particular, ensure your
children do not hang over or destabilize the TV; doing so may cause the TV to tip over,
causing serious injuries or death. Follow all safety precautions provided on the included
Safety Flyer. For added stability, install the anti-fall device for safety purposes, as follows.
To avoid the TV from falling:
1 Put the screws into the clamps and firmly fasten them onto
the wall. Confirm that the screws have been firmly installed
onto the wall.
➢
You may need additional material such as an anchor
depending on the type of wall.
➢
Since the necessary clamps, screws, and string are
not supplied, please purchase these additionally.
2 Remove the screws from the center back of the TV, put the
screws into the clamps, and then fasten the screws onto
the TV again.
➢
Screws may not be supplied with the product. In this
case, please purchase the screws of the following
specifications.
3 Connect the clamps fixed onto the TV and the clamps fixed
onto the wall with a strong string and then tie the string
tightly.
➢
Install the TV near to the wall so that it does not fall
backwards
.
➢
It is safe to connect the string so that the clamps fixed
on the wall are equal to or lower than the clamps fixed
on the TV.
➢
Untie the string before moving the TV.
4 Verify all connections are properly secured. Periodically
check connections for any sign of fatigue for failure.
If you have any doubt about the security of your
connections,contact a professional installer.
Securing the TV to the Wall
Pared
Pared
BN68-01807A-Eng.indb 47 2008-07-18 오전 8:00:07
To Next Page
Loading...
