Setting the PC
Preset to the PC mode by pressing the SOURCE button.
1 Press the MENU button to display the menu.
2 Press the ▲ or ▼ button to select Picture, then press the
ENTER button.
3 Select the required option by pressing the ▲ or ▼ button,
then press the ENTER button.
4 When you are satisfied with your setting, press the ENTER
button.
5 Press the EXIT button to exit.
Auto Adjustment :
Auto adjustment allows the PC screen to self-adjust to the
incoming PC video signal.
The values of fine, coarse and position are adjusted
automatically.
Easy Setting
1 Press the TOOLS button on the remote control.
2 Press the ▲ or ▼ button to select Auto Adjustment, then
press the ENTER button.
Screen: Coarse/Fine/Position/Image Reset
-Coarse/Fine
The purpose of picture quality adjustment is to remove or
reduce picture noise.
If the noise is not removed by Fine-tuning alone, then adjust
the frequency as best as possible (coarse) and Fine-tune
again.
After the noise has been reduced, re-adjust the picture so that
it is aligned on the center of screen.
1 Press the ▲ or ▼ button to select Coarse or Fine, then
press the ENTER button.
2 Press the ◄ or ► button to adjust the screen quality,
vertical stripes may appear or the picture may be blurry.
Press the ENTER button.
-Position
Adjust the PC’s screen positioning if it does not fit the TV
screen.
1 Adjust the position by pressing the ▲/▼/◄/► button.
2 Press the ENTER button.
-Image Reset
You can replace all image settings with the factory default
values.
Move
Enter
Return
Coarse 50
Fine 63
Position
Image Reset
Screen
T V
Move
Enter
Return
Position
T V
Auto Adjustment in Progress
Please wait.
Image Reset is completed.
OK
Move
Enter
Return
Mode : Standard
Cell Light 7
Contrast 80
Brightness 45
Sharpness 50
Auto Adjustment
Screen
Detailed Settings
More
Picture
T V
Tools
Anynet+ (HDMI-CEC)
Picture Mode Standard
Sound Mode Custom
Sleep Timer Off
SRS TS XT Off
Energy Saving Off
PIP
Auto Adjustment
Move
Enter
Exit
To Next Page
Loading...
