Screen Burn Protection
Congures the Screen Burn Protection Options to prevent and reduce pixel burn.
When an image remains in one position too long, it may cause a permanent burn on the screen.
Pixel Shift • : To reduce the possibility of screen burn, this unit is equipped with screen burn prevention technology.
This technology enables you to set picture movement up/down (Vertical) and side to side (Horizontal).
The Time setting allows you to program the time between movement of the picture in minutes.
Set
N
Pixel Shift to On by pressing the ▲ or ▼ button, then press the ENTERE button.
Select the required option by pressing the ▲ or ▼ button, then press the
N
ENTERE button.
Available options:
N
Horizontal, Vertical, Time.
Optimum condition for pixel shift
N
Item TV/Ext/AV/Component/HDMI/PC
Horizontal 0~4 2
Vertical 0~ 4 2
Time (minute) 1~4 min 3 min
The Pixel Shift value may differ depending on the monitor size (inches) and mode.
N
This function is not available in the
N
Screen Fit mode.
Scrolling • : This function helps remove after images on the screen by moving all the pixels on the PDP according to a pattern
Use this function when there are remaining after images or symbols on the screen especially when you displayed a still image
on the screen for a long time.
Side Grey • : When you watch TV with the screen ratio of 4:3, the screen is prevented from any damage by adjusting the white
balance on both extreme left and right sides.
Dark - : When you set the screen ratio to 4:3, it darkens the left and right sides.
Light - : When you set the screen ratio to 4:3, it brightens the left and right sides.
Picture Reset → Reset Picture Mode
❑
/ Cancel
Resets all picture settings to the default values.
Select a picture mode to be reset. The reset is performed for each picture mode.
N
Setting up the TV with your PC
Preset: Press the N SOURCE button to select PC mode.
Auto Adjustment
❑
Auto Adjustment allows the PC screen of set to self-adjust to the incoming PC video
signal. The values of ne, coarse and position are adjusted automatically.
This function does not work in DVI-HDMI mode.
N
Press the
T
TOOLS button to display Tools menu.
You can also set the adjustment by selecting Tools → Auto Adjustment.
Screen
❑
Coarse
Adjusts the frequency when vertical noise appears on the screen.
Fine
Adjusts the screen to be clearer.
PC Position
Adjust the PC’s screen positioning if it does not t the TV screen. Press the ▲ or ▼ button to adjusting the Vertical-Position.
Press the ◄ or ► button to adjust the Horizontal-Position.
Image Reset
You can replace all image settings with the factory default values.
Picture
Advanced Settings
Picture Options
Picture Reset ►
Brightness : 45
Sharpness : 50
Auto Adjustment
►
Screen
Advanced Settings
Picture Options
Picture Reset
Picture
To Next Page
Loading...
