5
English
Getting Started
Assembling the Cables
Enclose the cables in the Holder-Wire Cable so that the cables are not visible through the transparent
stand.
Getting Started
Checking Parts
Owner’s Instructions
Remote Control/
AAA Batteries (2ea)
Power Cord Cloth-Clean Screw (4ea)
Cover-Bottom Holder-Ring (4ea)
Ferrite Core for Power
Cord (1ea)
Holder-Wire Cable
The ferrite core is used to shield the cable from interference. When connecting a cable, open the ferrite core and clip it ■
around the cable near the plug.
Using the Stand-Base
Two or more people should carry the PDP. Never lay the PDP on the ■
floor because of possible damage to the screen. Always keep the PDP
upright.
The PDP can rotate 20 degrees in right and left directions ■ .
-20° ~ 20°
BN68-02355D.indb 5 2009-06-30 �� 10:34:06
To Next Page
Loading...
