Samsung QN Q65FNF Series - Page 46

3-2
3. Disassembly and Reassemble
Description & Screws Picture Description
3
Use Open Jig to release tape in corners and
all clips as indicated in red on sides and top &
bottom.
Gently lift up the Rear Cover starting at the
top being careful of function assembly at the
bottom.
When the 4 points (• )Hook is broken.
Although the hook is broken, the appearance
of the Rear cover is no problem and Gap
problem is not appeard after re-assembly.
To prevent the Inner Hook's broken.•
1. Catch the upper section of the rear cover.
2. Open the rear cover from top to bottom.
If the wire is bent, need to change the wire.•
Open Jigs
BN81-12884A BN81-14946A
<Bottom Conner>
Jig Direction
Jig Direction
Jig Direction
Locking tabs locations
49"•
Bottom : 8 point Locking
Top : 10 point Locking
L : 6 point Locking
R : 6 point Locking
Top Corner : 2 point (Snap Hook)
Side AV : 1 Point Locking
55"•
Bottom : 8 point Locking
Top : 10 point Locking
L : 6 point Locking
R : 6 point Locking
Top Corner : 2 point (Snap Hook)
Side AV : 1 Point Locking