3-6
3. Disassembly and Reassemble
Description & Screws Picture Description
9
Remove the DC VSS-PD BOARD. (Decomposition
order :
1
-
2
-
3
)
49" / 55" / 65"•
3
• Gently lift up (Top Left corner) to release
the lock and Slide Board to the Right.
Locking Fixing Hole
NOTE
1
Before Removing SMPS Board
You have to discharge the SMPS by using •
service JIG.
If LED ON 9 : LED OFF, discharge is
completed.
Measurement point
•
<Befor
e discharging>
<After
discharging>
LED ON LED OFF
A/S-DISCHARGE-JIG
BN81-16292A
Measurement point
Locking
Slide to the right to release the board
Bottom chassis Guide Fixing Hole
Insert the open Jig. Push SMPS-PANEL
connector for unlock and
lift up open JIG for SMPS
unlock.
1
2
3
3
To Next Page
Loading...
