EasyManua.ls Logo

Samsung RB28F Series - Interior Parts Removal and Reassembly; Refrigerator Cleaning Procedures

Samsung RB28F Series
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REMOVING THE INTERIOR
PARTS
When assembling, put fridge shelves in
the correct position and do not put them
upside down. It may cause a personal
injury or material damage.
When you put the shelves back, make
sure the side with the label “Front” on it
face the front of the refrigerator.
Shelves
Gently lift up the
shelves with both
hands and pull it
toward you. (Glass
shelf)
Do not put the shelves upside down or
backwards.
There is a risk of falling.
Door guards
Firmly grab the door
guards with both
hands and lift it up
gently to remove the
door guards.
Water tank
Lift up the Can Carry
and then rmly grab
the water tank with
both hands and lift it
up towards you gently
to remove the water
tanks.
Water tank may not be available
depending on the model.
Drawers
Pull the drawers out
fully then slightly lift
it up to remove the
drawers.
CAUTION
CAUTION
If the drawers get stuck to door, remove
drawer by lifting up after remove shelves.
CLEANING THE REFRIGERATOR
Do not use Benzene, Thinner or Clorox™
for cleaning.
They may damage the surface of the
appliance and can create a risk of re.
Do not spray the refrigerator with water
while it is plugged in, as it may cause
an electric shock. Do not clean the
refrigerator with benzene, thinner or car
detergent for risk of re.
1. Unplug the power cord of the refrigerator.
2. Slightly dampen a soft lint-free cloth or paper
towel with water.
Do not use any kind of detergent to clean
the refrigerator because that can discolor
or damage the refrigerator.
3. Wipe the inside and outside of refrigerator until
it is clean and dry.
4. Plug the power cord of the refrigerator.
When water
dispenser do not
come out water,
push on top of the
water tank down
slightly.
REPLACING THE LED LAMP
When the interior or exterior LED lamp has gone
out, do not disassemble the lamp cover and LED
lamp by yourself.
Please contact your service agents.
LAMP (LIGHT SOURCE)
This product contains a light source of energy
efciency class <G>.
The lamp(s) and/or control gear(s) are not user-
serviceable. To replace the lamp(s) and/or control
gear(s) in the product, contact a local Samsung
service centre.
For detailed instructions on replacing lamp(s) or
control gear(s) in your product, visit the Samsung
website (http://www.samsung.com), go to
Support > Support home, and then enter the
model name.
For detailed instructions on dismantling lamp(s)
and/or control gear(s), simply follow the
replacement instruction reached as described
above.
WARNING
CAUTION
operating _25
02 OPERATING02 OPERATING

Related product manuals