Basic position
Position reversed
10. Remove the Cap Handle and the Screws by
Flat-Head (-) screwdriver.
Remove the Cap by Flat-Head (-)
screwdriver and assemble the Handle and
Cap-Handle.
If the handle is not installed, skip steps 10
and 11 because they are not applicable.
Availability of these steps depends on the
model.
Be careful the Scratch, when
disassembling the Cap.
11. Assemble the Cap.
CAUTION
12. Switch the position of cap screw and cap.
Pull out using a thin at screwdriver.
Be careful not to injure yourself during
operation.
13. Lay the refrigerator carefully on it’s back.
Remove the leg (unscrew in an anti-clockwise
direction) and the Hinge Low.
Hinge Low
Leg
To protect the refrigerator damage, cut a
large section of the cardboard carton and
place it under the refrigerator.
14. Assemble the Middle hinge using the Phillips
Head (+) screwdriver. (Assemble Washer
upwardly before assembling Middle hinge.)
Washer (optional)
CAUTION
28_ operating
To Next Page
Loading...
