26
AATesting operations
Short push Display contents SEG1 SEG2 SEG3 SEG4 Unit
1 Order frequency 1 Hundreds' digit Tens' digit Unit digit Hz
2 Current frequency 2 Hundreds' digit Tens' digit Unit digit Hz
3 The number of current indoor units 3 Hundreds' digit Tens' digit Unit digit Hz
4 The sensor for outdoor air intake 4 + / - Tens' digit Unit digit °C
5 Discharge sensor 5 Hundreds' digit Tens' digit Unit digit °C
6 Eva-Mid sensor 6 + / - Tens' digit Unit digit °C
7 Cond sensor 7 + / - Tens' digit Unit digit °C
8 Current 8 Tens' digit Unit digit The rst place of decimals °C
9 Fan RPM 9 Thousands' digit Hundreds' digit Tens' digit rpm
10 Target discharge temperature A Hundreds' digit Tens' digit Unit digit °C
11 EEV B Hundreds' digit Tens' digit Unit digit step
12 The capacity sum of indoor units C Tens' digit Unit digit The rst place of decimals kW
13 Protective control D
0: Cooling
1: Heating
Protective control
0: No Protective control
1: Freezing
2: Non-stop defrosting
3: Over-load
4: Discharge
5: Total electric current
Frequency status
0: Normal
1: Hold
2: Down
3: Up_limit
4: Down_limit
-
14 The temperature of heat radiating plate E Hundreds' digit Tens' digit Unit digit -
15 S/W check F - - - -
Long push 1 Main micom version Year (Hex) Month (Hex) Date (Tens' digit) Date (Unit digit)
After short push 1 Inverter micom version Year (Hex) Month (Hex) Date (Tens' digit) Date (Unit digit)
After short push 1 E2P version Year (Hex) Month (Hex) Date (Tens' digit) Date (Unit digit)
※ Long push K4(Main micom ver.) short push 1 more(Inv. micom ver.) short push 1 more(E2P. ver.)
※ When snow prevention mode is in use, eco mode(standby mode)will not be functional.
7. DIP switch option
6. View Mode : When the K4 switch is pressed, you can see information about our system state as below.
On (default) O
switch 1 Auto address Manual address
switch 2 - -
switch 3 Disable snow prevention control Enable snow prevention control
switch 4 - -
RC＊＊＊DHXEA_IM_E_32793A(5).indd 26 2011-03-09 오후 9:32:46
To Next Page
Loading...