Samsung RC090DHXEA - Outdoor Unit Installation

8
Outdoor unit installation
(Unit : mm)
620
940
330 358
384
Anchor bolt hole
The outdoor unit must be installed on a rigid and stable base to avoid any increase in the noise level and vibration, particularly
if the outdoor unit is to be installed in a location exposed to strong winds or at a height, the unit must be fixed to an appropriate
support(wall or ground).
Fix the outdoor unit with anchor bolts.
• Theanchorboltmustbe20mmorhigherfromthebasesurface.
• Makeadrainoutletaroundthebaseforoutdoorunitdrainage.
• Iftheoutdoorunitisinstalledontheroof,youhavetochecktheceilingstrengthandwaterprooftheunit.
When installing air guide duct
• Checkandmakesurethatscrewsdonotdamagethecopperpipe.
• Secureairguideductonguardfan.
Outdoor Unit Support
20mm
Anchor bolt
Outdoor
Unit
Base Surface
Outdoor Unit
Support
Soft rubber designed to
cutoffvibrationfromrack
towall.(notsuppliedwith
product)
Designed to cut off
residualvibration
from outdoor unit to
rack.(notsupplied
withproduct)
OUTDOOR UNIT INSTALLED ON THE WALL BY RACK
 -Ensurethewallwillbeabletosuspendtheweightofrackandoutdoorunit;
 -Installtherackclosetothecolumnasmuchaspossible;
 -Installpropergrommetinordertoreducenoiseandresidualvibration
transferredbyoutdoorunittowardswall.
RC���DHXEA_IM_E_32793A(6).indd 8 2011-03-24 �� 10:02:41