4-5 Samsung Electronics
Troubleshooting
7
8
9
10
11
12
Press button, then the default value is .
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Setting is not required if you must
a volue which has a default.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
7
8
9
10
11
12
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key,
to set the display part to and check the display part.
The display part shows
.
Press the Mode Selection key,
to set the display part to and check the display part.
The display part shows
.
Step 4 :
Pressing the ON/OFF button(
).
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound ’’Ding’’ or
’’Diriring’’ is heard and the OPERATION ICON(
) lamp of the display is flickering at the same time, then the input
of option is completed. (If the diriring sound isn’t heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run.
First, Remove the battery from the remote control.
Second, Re-insert the battery into the remote control.
Third, Press ON/OFF button(
) withthe direction of remote control for set.
• Error Mode
1
st
If all lamps of indoor unit are flickering, Plug out, plug in power plug again and press ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see
if the correct option code is set up for its model.
NS090SDXEA_E_SM_33623A(1)_1.indd 5 2011-04-08 �� 10:55:14
To Next Page
Loading...