To Next PageTo Next Page
Need help?Do you have a question about the Samsung RC140PHXEA and is the answer not in the manual?
General| Refrigerant | R410A |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Type | Split |
| Operating Temperature (Cooling) | 18°C to 32°C |
| Cooling Capacity | 14000 BTU/h |
Provides essential safety information and guidelines for handling the air conditioner.
Covers crucial safety aspects related to the unit's installation process.
Details safety requirements for electrical connections and power supply.
Details different outdoor unit types, their models, and physical dimensions.
Provides instructions on safely moving the outdoor unit using wire ropes.
Guides on selecting an appropriate and safe location for the outdoor unit.
Specifies clearance dimensions for single outdoor unit installations.
Details clearance dimensions for installations with multiple outdoor units.
Instructions for securing the outdoor unit using anchor bolts.
Describes different methods and considerations for supporting the outdoor unit.
Illustrates system wiring diagrams for 1-phase and 3-phase connections.
Details specifications for power supply cables required for the air conditioner.
Provides specifications for indoor/outdoor connection and communication cables.
Details the specifications for 1-phase and 3-phase terminal blocks.
Shows the wiring diagram for the DRED system.
Illustrates the wiring for the silence mode controller.
Explains how to connect cables to the power terminal using ring terminals.
Provides details on cable connection methods and tightening torque requirements.
Outlines the refrigerant piping system and maximum allowable lengths.
Details temper grade and minimum thickness for refrigerant pipes.
Provides initial steps for adding R-410A refrigerant.
Covers regulations and methods for refrigerant charging.
Explains how to calculate the quantity of additional refrigerant needed.
Lists DPM compatible outdoor and indoor unit models.
Specifies space requirements for DPM installation.
Details connecting communication lines for DPM systems.
Describes DPM operation, specifications, and control methods.
Provides instructions for installing and operating DPM systems.
Explains how to set the number of indoor units for DPM.
Details procedures for connecting pipes and purging air from the system.
Instructs on connecting the drain hose for safe water drainage.
Provides guidelines for insulating refrigerant pipes to prevent condensation.
Step-by-step guide on how to open the stop valve.
Step-by-step guide on how to close the stop valve.
Details the procedure for pump down during unit relocation.
Verifies power supply, cable connections, and basic unit components.
Details how to run and check various test modes like heating, cooling, and defrost.
Explains procedures for resetting the outdoor unit power and disabling eco mode.
Guides on accessing system state information via the K4 switch.
Covers settings for DIP switches SW507 and SW508 for various functions.
Explains how to configure silence mode using DIP switches.
Lists and explains error codes related to the outdoor unit.
