4-2 Samsung Electronics
4-1-2 Setting an indoor unit installation option
1
The menu will display .
Press the
button until is displayed.
2
Press the button.
The current DIP option code set in an indoor unit will be
displayed.
3
Press button and change the page number.
The total option codes are 24digits.you can set six digits at a
time and it is distinguished by page number(0,1,2,3).
Page number DIP OPTION CODE
In order to check and set the indoor unit DIP option code using the wired remote controller, hold
down the
and buttons at the same time for 5 seconds.
SGE1 SGE2 SGE3 SGE4 SGE5 SGE6
0 2 RESERVED
Exterior temperature
sensor
Central control RESERVED
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 Drain pump
RESERVED RESERVED RESERVED Master / Slave
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 External control
External control output S-Plasma ion Buzzer
Number of hours
using filter
SEG19 SEG20 SEG21
---
3
Individual control
of a remote
controller
Heating setting
compensation
---
To Next Page
Loading...