4-4 Samsung Electronics
Model Option code for indoor unit
NS100HHXEH 011014-15624F-276470-370000
NS125HHXEH 011034-156123-277D8C-370000
NS140HHXEH 011034-116189-278CA0-370000
NS155HHXEH 011034-116189-279BAA-370000
NS180HHXEH 011074-1660C6-27B4D2-370000
In order to set the indoor unit option code using the wired remote controller, hold down the and
buttons at the same time for 5 seconds.
1 The menu will display
.
Press the
button to enter the indoor unit option code
mode.
2
Press the
button to change the page. You can change the
page from 0 to 3.
3
Press the
buttons and the button to set the
option code in order.
4
Press the
button to save the changed setting.
You will move to the menu selection display.
•
Option code will not be applied if you don’t press the button.
•
Setting indoor unit option code is only possible in Master wired remote controller.
You can only check the indoor unit option code in Slave wired remote controller.
•
Setting indoor unit option code is possible when one indoor unit is connected. If more than 2 indoor
units are connected, you can only check the Master indoor unit option code.
• The first digit represents the page number
and the remaining five
digits are option codes.
• The option code which is currently setting
will flicker.
• Press the button anytime during setup to exit without setting.
4-2 Option code Setting
Page No.
Option code
To Next Page
Loading...