REATTACHING THE REFRIGERATOR DOORS
Assemble the Refrigerator doors
1. Reattach two flat head screws(
1
) and two hex head
screws(
2
) to the hinge completely.
2. Place the hole in the bottom of the door(
3
)over the lower
hinge (
4
)
Be aware not to miss the hinge cap because it can
be easily taken off.
3. Insert the upper hinge shaft(
5
) into the hole on the
corner of the Refrigerator door(
6
). Make sure the hinge
is level between the upper hinge hole(
7
) and the hole of
the cabinet(
8
) and reattach the hinge screws(
9
) and
ground screw(
10
) by turning in a clockwise direction.
Reconnect the wires.
4. Place the front edge of the top table(
11
) on the front of the
upper hinge(
12
) and reattach with three screws.
When reattaching the top table, make sure that the
wires are not pressed or damaged by the top table.
5
6
7
8
9
10
12
11
To Next Page
Loading...
