Samsung RF266AB - Page 11

REATTACHING THE REFRIGERATOR DOORS
Assemble the Refrigerator doors
1. Reattach two flat head screws((_) and two hex head
screws(G ) to the hinge completely.
2. Place the hole in the bottom of the door((_))over the lower
hinge (@)
[_Be aware not to miss the hinge cap because it can
be easily taken off.
@
\
3. Insert the upper hinge shaft(_]_) into the hole on the
corner of the Refrigerator door((_}). Make sure the hinge
is level between the upper hinge hole([_) and the hole of
the cabinet((_}) and reattach the hinge screws((_) and
ground screw((_}) by turning in a clockwise direction.
Reconnect the wires.
\
®
4. Place the front edge of the top table((_)) on the front of the
upper hinge([_) and reattach with three screws.
_When reattaching the top table, make sure that the
wires are not pressed or damaged by the top table.
Settng Up 11