28
ADJUST THE CLEARANCE BETWEEN THE DOORS
Making small adjustments between doors.
If the door of the freezer is lower than that of
the refrigerator.
If the door of freezer is higher than that of the
refrigerator.
3) After adjusting the doors, turn the nut (①) turn clockwise( ) until the lower end of the bolt, then tighten
the bolt again with the wrench (➂) to fix the nut(①).
If you do not fix the nut (
①
) firmly, the bolt (
➁
) may be released.
2) Please adjust the height difference between the doors turning the bolt (➁) turn clockwise( ) or
counter clockwise ( ).
When you turn clockwise ( ), the door goes up.
➂ WRENCH
Adjustment part
Adjustment part
➀ NUT
➁ BOLT
➂ WRENCH
➀ NUT
➂ WRENCH
➀ NUT
➂ WRENCH
➀ NUT
➁ BOLT
➂ WRENCH
➁ BOLT
➂ WRENCH
➁ BOLT
➁ BOLT
➁ BOLT
Please open the doors and adjust the doors as follows:
1) Release the nut (
①
) on the lower hinge until the upper end of the bolt (
➁
).
When you release the nut(
①
), use enclosed hex wrench (
➂
) to turn the bolt(
➁
) a little counter clockwise
to make the nut(
①
) loose with your fingers.
NOTA
NOTE
NOTA
DA99-00494V (EN)-0.2 0504 5/5/05 4:57 AM Page 28
To Next Page
Loading...
