37
This document cannot be used without Samsung's authorization
PRECAUTIONS(SAFETY WARNINGS)
3-13. Main PCB and Inverter PCB Disassembling (whole)
Work sequence Remarks
1. Pull the refrigerator forward to make space for
servicing.
2. Disassemble the four screws.
- New issued model use 5 screw.
3. Disassemble the thirteen connectors of the
housing(Number of the housing connectors may vary
dependent upon models and functions).
While pressing the upper hook on the location shown
on the gure, pull the main main PBA and remove it.
4. Disassemble the ve connectors of the housing.
While pressing the hooks on the left and the right side
on the locations shown on the gure, pull the inverter
PBA and the SMPS PBA to remove them.
(It will be a little difference each model)
To Next Page
Loading...
