62
This document cannot be used without Samsung's authorization
PRECAUTIONS(SAFETY WARNINGS)
■ To connect the cold water pipe to the water ltering hose
■ To repair the water line
1. Loosen and remove the compression nut (a) from
the water line of the refrigerator, and insert it to
the water ltering hose.
2. Tighten up the compression nut (a) to connect the
water ltering hose and the water line.
3. Open the main water valve and check for any
leaks.
4. If there are no leaks, dispense about 10 litres
of water or dispense the water for 6 - 7 minutes
before actually using the refrigerator to remove
impurities inside the water ltering system.
5. Secure the water line to a sink or a wall using a
clip.
CAUTION
• Do not tighten the water line excessively. Make sure the
water line is not bent, pinched, or squashed.
• Do not mount the water line on any part of the
refrigerator. This may damage the refrigerator.
NOTE
If you have to relocate the refrigerator after connecting
the water line, make sure the joined section of the water
line must is straight.
CAUTION
The water line must be repaired by a qualied professional. If you encounter a water leak, contact a local
Samsung service centre or the installer of the water line.
To Next Page
Loading...
