64
This document cannot be used without Samsung's authorization
PRECAUTIONS(SAFETY WARNINGS)
■ Water lter replacement (applicable models only)
CAUTION
• Do not use third-party water lters. Use only Samsung-provided or -approved lters.
• Unapproved lters may leak and damage the refrigerator, causing electric shock.
Samsung holds no responsibility for any damage that may occur from use of third party water lters.
• The lter indicator turns red as a reminder that lets you know it is time to replace the water lter.
1. Shut off the main water supply.
2. Connect the water supply line to the inlet side of
the lter to the end.
3. Connect the dispenser line to the outlet side of
the lter.
4. Check if there is any leak. If not, x the lines with
the clips.
5. Put the water lter into place and x it with the
clips.
6. Press and hold Filter Reset for 3 seconds to reset
the lter lifecycle.
7. When replacing is complete, ush 10 litres of
water (or dispense the water for 6 - 7 minutes) to
remove impurities from the water line.
CAUTION
When adjusting the length of the water line tubing, make
sure to smooth out the cut surface at a right angle.
This is to prevent a water leak.
NOTE
• A newly installed lter may cause the water dispenser to spurt water briey. This is because air has
entered the water line.
• This replacement process may involve the refrigerator to drip water onto the oor. If this happens, wipe
up with dry cloths.
To Next Page
Loading...
