2. Panel
16
. Installation
Λ
Λ
4) Install the air flow blade.
4-1 Fix the right part of the blade to the indoor unit.
4-2 Fix the other side of the blade.
4-3 Fix the middle part of the blade by pushing slightly the
middle tab in the indoor unit.
5) Open the electrical component box by removing screws,
then connect cables between the electrical component box
and the panel.
6) Fix the panel by fastening 4 bolts; the bolt can be fastened
up to 15mm.
7) Reinstall the front grille.
➁
①
➂
Indoor unit
Panel
Insulation
Must fit tightly against the ceiling without any gap
◆ If the direction is incorrect, the blade will not be
inserted smoothly. Check that prominence of the
right side has a small rectangular groove.
IMPORTANT
◆ Be careful about the color of cables not so that they will
be mixed up.
IMPORTANT
Panel
Standard
length:20mm
Indoor unit
◆
If there is a gap between the panel and the ceiling, adjust
the height of the indoor unit. Unless adjust the height,
dew may form and drip from the gap.
DVM TM(chapter5-1)_E<03759 6/14/02 2:31 PM Page 16
To Next Page
Loading...