25
2nd
3rd Description
Source Detection
Select either Auto or Manual as the method to recognise input source.
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected, a command responds only once when a button is pressed.
Power LED On
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
Reset All
• Return all the settings for the product to the default factory settings.
To Next Page
Loading...
