12
When the monitor displays nothing (i.e. Power saving mode or Non-signal mode), 2 direct keys for
control source and power could be used as below.
JOG Button Power saving/Non-signal mode
UP
Source Change
Down
PRESS(ENTER) for 2 seconds
Power Off
When the monitor displays the Main menu the JOG Button could be used as below.
JOG Button Action
UP/DOWN
Move the option
LEFT
Exit the Main menu.
Close Sublist without saving value.
Value decreases in the slider.
RIGHT
Move to next depth.
Value increases in the slider.
PRESS(ENTER)
Move to next depth.
Save the value and close Sublist.
Changing Brightness, Contrast and Sharpness settings
You can adjust Brightness, Contrast or Sharpness by moving the JOG button up or down, if no OSD
menu is displayed.
Brightness
Contrast
Sharpness
100
―
The displayed image may differ depending on the model.
―
The default brightness can vary depending on the region.
Brightness
―
This menu is not available when
Bright is set to Dynamic Contrast mode.
―
This menu is not available when
Eco Saving Plus is enabled.
―
This menu is not available when
Eye Saver Mode is enabled.
Contrast
―
This menu is not available when
Bright is in Cinema or Dynamic Contrast mode.
―
This menu is not available when
Game Mode is enabled.
Sharpness
―
This menu is not available when
Bright is in Cinema or Dynamic Contrast mode.
―
This menu is not available when
Upscale is in Mode1 or Mode2 mode.
―
This menu is not available when
Game Mode is enabled.
To Next Page
Loading...
