- 9 -
S32DM80*
1 2
3
Put the stand base onto the stand neck
as the direction shown in the figure.
Check that the stand neck is firmly
connected.
Tightly fasten the connecting screw at
the bottom of the stand base.
As shown in the figure, remove the
product and foam cushion, and then
place the product on the table with its
front side facing the floor.
4
5
Push the assembled stand into the main body in the direction of the arrow as
shown in the figure.
Confirm that the stand is tightly fastened. If
has not been fully lowered, lower it
while holding it with your hand.
Stand assembly is complete.
Caution
Do not arbitrarily remove the panel
film. If not observed, the warranty
service may be restricted.
To Next Page
Loading...
