Samsung SCL530 - Service Mode Entry and Button Functions

Samsung Electronics4-4
Alignment and Adjustment
The function keys left case is required to adjust the camera section.
Note : In service adjustment mode, button names are different from those in customer camera function
control mode. EX) PROGRAM AE button is the same as confirm.
5. How to get into service “ADJUST” mode
1. Remove the lithium battery from the
camcorder.
2. Connect the power source (battery/
DC cable).
3. Eject the tape if it is in the unit.
4. Set the power switch of the
camcorder to “CAMERA” position.
5. Set OSD on state.
STEP 1
1. Press and hold the “EJECT” button and
“DATE/TIME” button on the camcorder at the
same time for more than 5 seconds.
Then unit goes into service mode.
STEP 2
On screen display show “0DF. T.INI XX XX”
CAMERA ADJUSTMENT mode has suc-
cessfully been activated.
STEP 3
Note : When “XX XX” is shown in service adjustment procedures, this indicates variable values.
EJECT
MODE DOWN
MODE UP
Confirm
DATA UP
DATA DOWN
FAR
NEAR
MANUAL
FOCUS
DATE/TIME