Samsung SCL530 - Page 50

Samsung Electronics 4-31
Alignment and Adjustment
6. TINT(ADDRESS : 0.TINT)
1) Connect an oscilloscope probe to TP-B.
2) Adjust the EVR so that the dual waveforms are
superimposed.(PAL MODEL)
3) Adjust the EVR so that the bright(Green) level
is equal to the Red level.(NTSC MODEL)
DUAL WAVEFORMS ARE SUPERIMPOSED.
ADJ. point
1. PLL 3. R-SUB BRIGHTNESS2. BRIGHTNESS
10P CON
4. B-SUB BRIGHTNESS
5. COLOR
6. HUE
Note : When adjusting CVF be sure to short cir-
cuit between Ground and “A”part to store
the confirmed data in EEPROM when
pushing ON/OFF button.
A
GND
G
R
B
P
L
CVF Adjust Mode
(Short)
YELLOW LEVEL
PEDESTAL
LINE
GREEN LEVEL
RED LEVEL