Samsung Electronics 4-35
Alignment and Adjustment
Notes: For LCD adjustment, use the buttons on the video camera and the remote control.
After each adjustment step is completed, OSD shows "OK".
EEPROM(ICL202) stores confirmed adjustment value of each adjustment step.
After finishing the adjustment, turn power off.
4-2-5 (a) PREPARATION
1. How to get into the LCD adjust mode.
When monitor OSD shows as above screen, LCD
adjustment mode has been activated successfully.
Note : "XX" indicates variable values.
Monitor screen
Remote Control Button Location
VCO
EPR:XX EVR:XX
A.
4-2-5 LCD Adjustment
1. Remove the lithum battery from cam-
corder.
2. Connect the power source (battery/DC
cable).
3. Set the mode switch of the camcorder to
“PLAYER” position.
4. Camera screen and OSD appears.
STEP1
Press and hold the “EJECT” button and “FF”
button on the camcorder at the same time for
more than 5 seconds.
STEP2
EJECT
MODE DOWN
MODE UP
Confirm
DATA UP
DATA DOWN
FF
To Next Page
Loading...
