4)
Progress Status Bar will run, automatically.
That is just file transferring between PC and product.
※ If USB cable has unplugged or Off the power
while being upgraded, F/W file transfer will stop.
5)
Complete F/W file transfer, then unplugged cable.
Next, F/W Upgrade should be required on
Camera itself.
※
“
Next step
”
process is only for Camera product.
Camcorder does not need further process for
upgrading
------------------------------------------
This page is for Camera, only
-----------------------------------------------------
6)
Turn on the camera, transferred F/W file,
then F/W upgrading message will be shown,
automatically.
※ If F/W upgrading does not run,
whenever the camera is on,
same message will pop-up.
To Next Page
Loading...
