Air Conditioner and Accessories
E-6
The following accessories are supplied with the air conditioner.
➢ The quantities are indicated in parentheses.
Accessories in the Indoor Unit Case
Accessories in the Outdoor Unit Case
➢ The five-wire assembly cable is depending on the option. [If they are not supplied, Using
the standard cable.(above 1.0mm
2
/area or approved according to IEC standard.)]
➢ The flare nuts, drain plug, drain cap A/B and rubber leg are only included when the air
conditioner is supplied without the assembly piping illustrated below.
The following connection accessories may be supplied, depending on the option. If they are not
supplied, it is recommended that you collect them together before starting to install the air
conditioner.
➢ If these accessories are supplied, they are located in the accessory box.
Installation Plate (1) FH.M4 x 12 Tapped
Screws (2)
Remote Control (1)
Remote Control
Holder (1)
Five-wire Assembly
Cable (1)
Drain Cap A (1)
Drain Cap B (1) Drain Plug (1)
Flare Nuts, 6.35mm
outer pipe diameter (2)
Flare Nuts, 9.52mm
outer pipe diameter (2)
(✴✴07✴✴, ✴✴09✴✴)
Flare Nuts, 12.70mm
outer pipe diameter (2)
(✴✴12✴✴)
Batteries for
Remote Control (2)
Owner’s Instruction
Booklet (1)
Installation Manual (1)
PREPARING THE INSTALLATION
M3.8 x 20 Screws
for Wood (10)
Putty 100g (1)M4 x 16 Tapped
Screws (10)
Drain Hose,
length 2m (2)
Rubber LEG (4)
Assembly Piping,
Ø6.35mm by 5m
(1)
Assembly Piping,
Ø9.52mm by 5m (1)
(✴✴07✴✴, ✴✴09✴✴)
Assembly Piping,
Ø12.70mm by 5m (1)
(✴✴12✴✴)
PE T3 Foam Tube
Insulation (1)
Vinyl Tape,
Width 50mm (1)
Drain plug (1) Rubber LEG (4)
Pipe Clamps B (3)
Pipe Clamps A (3)
Drain Cap B (1)
Drain Cap A (1)