11Samsung Electronics
Disassembly and Reassembly
No Parts Procedure Remark
2
3
4
Electrical Parts
(Main PCB)
Tray Drain
Heat Exchanger
1) Take all the connector of PCB upper side
out.(Including Power Cord)
2) Detach the outdoor unit connection wire
from the Terminal Block.
3) If pulling the main PCB up, it will be taken
out.
1) Pull Tray Drain out from the Back Body.
1) Loosen 2 fixing earth screws of right side.
2) Detach the Connection Pipe.
3) Detach the Holder Pipe at the rear side.
4) Loosen 3 fixing screws of right and left
side.
5) Detach the Heat Exchanger from the
indoor unit.
DB98_16693A(2)_1 3/19/04 2:10 PM Page 11
To Next Page
Loading...
