Samsung SH12ZS4AX - Page 18

17Samsung Electronics
Set Up the Model Option
7
8
9
10
11
12
7
8
Press button, then the default value is .
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
✳ Setting is not required if you must
a value which has a default.
9
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
10
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
11
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
12
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Step 4 : Pressing the ON/OFF button ( )
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON( ) lamp of the display is flickering at the same time, then the input of option is com-
pleted. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
1
st
If all lamps of indoor unit are flickering, Plug out, plug in battery again and press ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
set up for its model.
DB98_16693A(2)_1 3/19/04 2:11 PM Page 17