v
Maintaining Water and DustResistance
This device is rated IP68 using the Ingress Protection rating system.
Your device has been tested in a controlled environment and shown to be water and dust resistant in certain circumstances
(meets requirements of classification IP68 as described by the international standard IEC 60529 – Degrees of Protection provided
by Enclosures [IP Code]; test conditions: 15-35°C, 86-106 kPa, 5.0 feet, for 30 minutes). Despite this classification, your device is not
impervious to water damage in any situation. It is important that all compartments are closed tightly.
If any liquid is found to have entered your device components or an internally sealed system, this condition will void
your device warranty.
Follow these tips carefully to prevent damage to the device.
•
Any device which uses accessible compartments or ports that can be opened, should have these sealed or closed tightly to
prevent liquid from entering the system.
• Whenever your device gets wet, dry it thoroughly with a clean, soft cloth. If your device has gotten wet, you should dry the inside
of the charging port before inserting a power connector to charge your device. If the charging port is not fully dry, your device may
operate abnormally. For example, it may charge more slowly or overheat.
To Next Page
Loading...
Need help?
General