Disassembly and Assembly
66
10
Heat the microwaveable heating bag additionally and apply it on the top edge of the
back cover for 3 minutes.
11
Place the suction cup in the center of the top edge of the back cover, lift upwards, and
then insert the opening pick in the gap at the top right edge.
•
As the back cover can be damaged by excessive force, be careful not to damage
the back cover.
•
As the internal circuitry can be damaged, do not insert the opening pick more
than 3 mm.
If you have trouble creating a gap, heat the microwaveable heating bag
additionally, and apply it on the back cover to further soften the adhesive. When
reheating, it should be heated no longer than 30 seconds.
To Next Page
Loading...