Need help?Do you have a question about the Samsung SM863a and is the answer not in the manual?
General| NVMe | - |
|---|---|
| Interface | Serial ATA III |
| Read speed | 410 MB/s |
| Write speed | 450 MB/s |
| SSD capacity | 240 GB |
| SSD form factor | 2.5\ |
| Random read (4KB) | 90000 IOPS |
| Data transfer rate | 6 Gbit/s |
| Random write (4KB) | 10000 IOPS |
| S.M.A.R.T. support | Yes |
| Security algorithms | 256-bit AES |
| Mean time between failures (MTBF) | 2000000 h |
| Product color | Black |
| Operating voltage | 5 V |
| Power consumption (idle) | 1.3 W |
| Power consumption (read) | 2 W |
| Power consumption (write) | 2.5 W |
| Operating shock | 1500 G |
| Storage temperature (T-T) | -40 - 85 °C |
| Operating temperature (T-T) | 0 - 70 °C |
| Storage relative humidity (H-H) | 5 - 95 % |
Weight and Dimensions| Depth | 6.8 mm |
|---|---|
| Width | 100.2 mm |
| Height | 69.85 mm |
| Weight | 64.3 g |
Hold the SSD by its side areas without squeezing strongly. Use anti-static gloves and wrist straps for ESD protection.
If the side area is not accessible, hold the area opposite connectors. Avoid touching the connector area directly.
Do not stack multiple SSD units on top of each other to prevent potential damage.
Handle SSDs carefully on hard surfaces. Avoid dropping, knocking over, or hitting the drive to prevent severe damage.
Do not place the SSD directly on solid objects, as this could impact the drive cover and cause failure.
Do not touch connectors with metal objects. Never attempt to open the drive casing to avoid damage.
Connect SATA cables securely. Insert or remove SSDs only when connectors are fully engaged; hold the drive by its sides.
To Next Page