SAMSUNG Proprietary-Contents may change without notice
Test Procedure
6-8
This Document can not be used without Samsung's authorization
- PCS Test items
TEST ITEMS PROCEDURE
1. PREPARANCE
Set test equipments up.
[47*869#1235]: EntertheTestMode
"001" :Suspend
Confirm that the phone is in the "PCS Mode".
(If not PCS Mode, Use Test Command "022""3XXXX" and Push
the
[OK]
Key,andenter"002"torestart)
If you select a wrong key, press " # ", then enter new command.
ToexittheTestModeatanytime,justpress[002].
2. FREQUENCY
ACCURACY
"001" :Suspend.
"0130600*":Setchannel to 600.
"0 1 1" : Carrier On.
"019XXX'END[PushandHold]'":SetAGCCode(XXX)level.
Measure the TX frequency : 1880.00MHz±300Hz.
3. OCCUPIED CDMA
BANDWIDTH
"001" :Suspend.
"0130600*":Setchannel to 600.
"0 1 1" : Carrier On.
"0 1 4" : Spread spectrum.
"019XXX'END[PushandHold]'":EnterAGCCode(XXX) to adjust
RF Output Power.
Measure the bandwidth (spec: 1.23MHz).
4. LIMITATIONS ON
EMISSIONS
"001" :Suspend.
"0130600*":Setchannel to 600.
"0 1 1" : Carrier On.
"0 1 4" : Spread spectrum.
"010Select1 *":SetPA_R1toHighGainMode
"019XXX'END[PushandHold]'":EnterAGCCode(XXX) to adjust
RF Output Power.
Measure the spurious at F
C
±1.25MHz
spec: F
C
±1.25MHz below 42dBc/30kHz
5. GATED POWER &
TIME
Set the service option 2.
Set the data rate Eighth (1200bps).
Registering: HHP
→
HP8924C.
Call : HP8924C
→
HHP.
Measure the Gated Power & Time.
spec : Gated Power - at least 20dB
Gated Time - Rising Time : below 6
㎲
Falling Time : below 6
㎲
Burst Time : below 1.247
㎳
To Next Page
Loading...
