Please lift up and pull out the water tank.
• Please hold the groove of both hand grips and
pull out the water tank while lifting it up.
• Please clean the inside of water tank when using
it for the first time.(Refer to page 21)
Please close the refrigerator door
after inserting the water tank.
• Please confirm whether the water
exit of water supply device is outside
after closing the door.
Please press down the water sup-
ply lever with hands after placing
cup on platform for cup.
Please fill the water tank with water after placing it up on flat surface except for water sup-
ply device.
• Please supply the water up to 2.5l of water level window since water may overflow when clos-
ing the round lid if water is too full.
• It is possible to fill the water with water tank inserted in the refrigerator.
Groove for hand-grip
Water level window
Round lid
Water tank
Water supply device
Hand-grip
Method 1.: Please fill the water after lift up the round lid
to the arrow direction to open it.
Method 2.: Please fill the water after holding and lifting
both hand-grips of large lid to open it.
• Please lay the cup deep inside to the extent the
cup can reach the inner wall slightly.
• If hands were removed from cup, there is no
water supplied.
• Please desert 2~3 cups of water when using the
water dispenser for the
first time after
installation.
• In case of continuous
water drinking, about
10~15 cups of water
are availble.
Water supply lever
SR-608, 606/ENG 11/15/59 4:19 PM Page 21
To Next Page
Loading...
