EasyManua.ls Logo

Samsung SR-S20DTC - Water Supply Tube Installation; 17-1) Check and Control Ice Maker Water Supply Amount

Samsung SR-S20DTC
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17.
Installation
Method
of
Water
Supply
Tube
10;
Check
the
amount
of
supplied
water
toe
icemaker:
(The
Method
to
control
the
amount
of
water
supply
to
the
ice
maker]
1)
Remove
the
upper
ice
maker
from
the
refrigerator.
1.
First,
change
control
panel
to
option
change
mode.
Press
“Freezer
Temperature”
button
and
“Vacation”
button
simultaneously
for
about
12
seconds,
temperature
display
will
change
to
option
change
mode
with
beep
2.
The
number
of
right
display,
refrigerator
temperature
display,
is
the
kind
of
option.
Press
“Refrigerator
Temperature”
button,
the
number
increases.
Also,
press
“Vacation”
button,
the
number
decreases.
Set
the
number
to
3.
3.
The
number
of
left
display,
freezer
temperature
display,
is
the
data
of
each
option.
Press
“Freezer
Temperature”
button,
the
number
increases.
Also,
press
“Quick
Freeze”
button,
2)
When
the
test
button
is
pressed,
the
ice
cube
container
is
turned
and
then
water
is
the
number
decreases.
out
from
the
tap
of
the
ice
maker
where
water
is
supplied.
At
this
time,
check
the
Set
the
number
to
desired
number,
two
digit,
as
reght
table.
amount
of
water.(see
the
picture)
If
there
is
over-supply
of
water,
the
ice
cube
will
be
made
in
attached
form
of
2
to
4
ice
cubes.
If
there
is
less-supply
of
water,
the
ice
cube
will
be
made
in
small
size.
When
this
happens,
you
may
encounter
inconvenience
while
using.
This
is
not
a
problem
in
the
refrigerator.
It
is
the
problem
of
water
pressure
in
the
water
pipe
and
occurs
frequrently.
When
this
problem
occurs,
control
the
amount
of
water
supply
by
the
following
method.
the
amount
of
water
vets
we
4.
Setting
the
option
and
data,
please
wait
until
control
panel
is
changed
to
the
control
mode
automatically.
:
Notice
ea
;
When
setting
the
amount
of
water
-
supply,
do
not
select
the
large
amount
'
of
water
supply.
Set
step-by-step.
(Water
can
be
over
flowed.)
5.
If
the
option
control
is
completed,
check
the
amount
of
supplied
water
in
the
Ice
Maker.
CHECK
OF
THE
SUPPLIED
WATER
If
the
controlled
amount
of
water
supply
is
slightly
below
the
optimum
level,
it
is
O.K.
to
use.

Table of Contents

Related product manuals