13 Samsung Electronics
A. Function of controlling the temperature of freezer
1)
You can control the temperature of freezer from -17 to -25 at 1 interval by pushing the
control button of the temperature of freezer.(FRE. TEMP.)
2)
Temperature is displayed in following order -19 -20 -21 -22 -23 -24 -25
-17 -18 whenever you push the control button of temperature.
3)
The temperature of freezer is automatically set to be -19 on initial POWER ON.
References
1)
TFSET-ON : “Setting temperature of freezer
+3
”
2)
TFSET-OFF : “Setting temperature of freezer -
3
”
Controlled
temperature of freezer
7 Segment
Section
Power
1 time push 2 time push 3 time push 4 time push 5 time push 6 time push 7 time push 8 time push 9 time push
–19˚C
–19˚C
–20˚C
–20˚C
–21˚C
–21˚C
–22˚C
–22˚C
–23˚C
–23˚C
–24˚C
–24˚C
–25˚C
–25˚C
–17˚C
–17˚C
–18˚C
–18˚C
7-1. 7-Segments Display Function
7. Functions of Refrigerator
7-2. Function of Thermostatic Control
Section
Initial POWER
ON (Power s/w,
instantaneous
electricity failure)
Stabilization of the temperature in
the freezer (Since the setting
temperature have reached)
Defrosting
(precooling+defrosting+pause)
Super
Forced freezing
Forced defrosting
Display function of the
temperature of refrigerator
Display function of
the temperature of freezer
Notch setting
(YES)
Notch setting
(NO)
Function
Blink setting temperature of freezer until temperature reaches below
TFSET_ON +3
-- displayed (until the notch control is operated)
Blink if temperature goes above TFSET_ON +3 .
Display the setting temperature if the temperature goes below TFSET_ON +2
Display Blinking continuously ignoring temperature of freezer if displayed state of freezer before
defrosting was Blinking . Display Setting temperature of freezer continuously ignoring temperature of
freezer if displayed state of freezer before defrosting was Setting temperature of freezer .
Maintain temperature constantly while it reaches TFSET_OFF point When you return to the operating
cycle.
Blink if temperature goes above TFSET_ON +3
Display the setting temperature if the temperature goes below TFSET_ON +2
Display “ ”(Forced Freezing)
Display “ ”(Forced Defrosting)
If you push “REF. TEMP.” button indicative LAMP of refrigerator starts to
light up and blink the setting temperature of refrigerator.
If you do not input the KEY, it is blinked 5 times for 5 seconds at 0.5-
second interval and automatically converted to the displayed state of
setting temperature of refrigerator.
If you push “FRE. TEMP.” button indicative LAMP of freezer starts to light
up and blink the setting temperature of freezer.
If you do not input the KEY, it is blinked 5 times for 5 seconds at 0.5-
second interval and automatically converted to the displayed state of
setting temperature of freezer.
To Next Page
Loading...
