Connecting Your
Monitor
Installing the
Monitor Driver
Base Installation
With the built-in pedestal, you can tilt and/or swivel the monitor for the most comfortable
viewing angle.
Note:
The base is detachable.
Attaching the Base
1. Place the monitor upside-down on a flat work surface.
2. Align the tabs on the base with the corresponding slots on the bottom of the monitor.
3. Press the base onto the monitor until the tabs are fully engaged in the slots.
4. Push the base toward the front of the monitor until the release latch clicks into the locked
position.
* Do not bend the snap.
Removing the Base
5. Squeeze and pull up on the release latch on the base.
6. Push the base toward the back of the monitor and lift up to remove the base.
Note:
The base will align with the monitor slots in only one position.
To Next Page
Loading...
