Connecting a Speaker
When connecting a speaker, be careful that the grooves of the monitor and the speaker
( ) are aligned with each other.
Adjust the aligned positions until you hear a ‘click’. If a speaker is connected correctly, you
can hear a ‘click’.If a speaker is connected without you hearing a ‘click’, the holding part
may become damaged.
1.
Connect the power line connected to the speaker to the black terminal of the monitor.
This speaker is not connected to an external power source. It is connected to a monitor for
the required power.
2.
Connect the light green cable of the cables provided when purchasing the speaker to the
audio output terminal at the back of the computer.
Connect the other end of the cable to the light green terminal at the back of the speaker.
3.
Connect the red cable of the cables provided when the speaker was purchased to the audio
output terminal at the back of the computer.
Connect the other end of the cable to the red terminal at the back of the speaker.
4.
By turning part ( ) in the direction shown in the figure below, the speaker turns on and the
volume increases.
5.
To Next Page
Loading...
