2. Select the touchscreen you want in the list and Click [Calibrate]. After calibration, the item "Calibrated" will show "Yes".
Calibration compromising of steps: select a touchscreen in the information list, then click "calibrate" button when the calibration
window shows up. Calibration is done by clicking on 4 calibration points so that user only clicks the center of the bull's-eye in
sequence. If failing to hit the bull's eye, user may move the pointer or fingers to the center of it again and lift based on the
utilization of Click on Release when calibration. Press 'Esc" button to exit calibration. After calibration the "recalibrate", "OK",
"cancel" buttons will show up. "ReCalibrate" means recalibration; "OK" means saving and exit; "Cancel" means exit without
saving.
Modes Setting
To Next Page
Loading...
