Installing the Product 2-2
2-2 Installing the Stand
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
Insert the Stand Connector into the Stand in the direction shown by the figure.
Check if the Stand Connector is firmly connected.
Turn the connecting screw at the bottom of the stand fully so that it is completely fixed.
Open the back cover of the stand by pushing it toward the indicated direction (upwards at
45°).
Place a soft cloth over the table to protect the product and place the product onto the
cloth so that the front of the product is facing downwards.
Downloaded from ManualMonitor.com Manuals
To Next Page
Loading...
