3-1
3. Disassembly and Assembly
3. Disassembly and Assembly
This section describes the disassembly and reassembly sequences for this monitor.
Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them.
3-1. Disassembly
Caution: 1. Turn the monitor off before beginning the disassembly process.
2. When disassembling the monitor, do not use any metal tools except for the provided jig.
3. Disassemble the monitor carefully as directed in the following procedures.
Description Photo Screws
1. Place a soft cloth on the table and place
the monitor onto it with the front part facing
downwards. Hold the monitor set with one hand
and hold and pull the stand body backwards with
the other hand to remove the stand body from the
monitor set.
2. Insert both hands into the groove and then lift up
and remove the cover.
3. Remove the four (2) screws.
4. Remove the INVERTER wire, LVDS cable, and
FUNCTION cable, and then remove the SHIELD-
COVER.
INVERTER,
LVDS
FUNCTION
To Next Page
Loading...
